Chicharrón with Lime and Chili Salt

Ingredients

• 1
  
  large piece of pork skin, trimmed of fat (about 2 pounds of skin)
  
• 1
  
  quart pork lard or neutral oil for frying (you may not need this much, but you want to keep your oil clean)
  
• 1
  
  lime
  
• 2
  
  teaspoons kosher salt
  
• 1/4 to 1/2
  
  teaspoons chili powder (depending on your spice tolerance)
  

Directions

1. Ask your butcher to find you pork skin that is as hairless as possible (the par-boiling will help get rid of whatever hair remains). If your skin still has a large cap of white fat on it, use a sharp knife or bench-scraper to remove as much as you can.
2. Place the skin in a stockpot and cover it with about 4 inches of water. Place a plate on top of the skin to keep it below the water. Cover the pot and bring the water to a rapid boil. Lower the heat slightly and gently boil the skin for 2 hours, checking occasionally to make sure there is still water in the pot.
3. After 2 hours, remove the skin and allow it cool until you’re able to handle it. Gently remove any white fat that is left (this will be much easier now that the fat is softened from boiling). Scrape it off until only skin remains.
4. Pat the skin dry and place it on a perforated sheet pan with a non-perforated sheet pan underneath it (to catch any fat that renders out).
5. Set your oven to the lowest setting (usually that’s around 200° F), and dehydrate the skin for 8 to 10 hours. (Of course, if you’re lucky enough to have a dehydrator, use that!). The skin is done when it is brittle enough to crack cleanly into pieces.
   Once the skin is at this point, fill a pot with about 4 inches of melted lard or frying oil and heat it to 400° F.
6. Crack the skin into small pieces — roughly 1-inch squares — and fry them 1 to 2 at a time, poking them until they puff up and turn golden brown.
7. Transfer the chicharrón to a paper towel to drain them. Once they’ve cooled slightly, squeeze the juice of 1 lime over them and sprinkle with salt and chili powder.